- Orange-5 base software
- Generator of rectangular pulses, probe, logic analyzer, oscilloscope, emulator for CDC devices.
- Terminal program for work with COM ports.
- Orange-5 base software interface demo
Orange5 Orange 5 Programmer Software Download and Installation Guide :
Orange-5 Programmer is a professional general purpose programming device for memory and microcontrollers. Unique feature of the current series programmers is built-in macrolanguage for writing down protocols, which gives fast and easy capability to add new types of ICs, precisely meeting manufacturers' requirements to read/write algorithms.
Hardware Features :
- Universal easy to plug panel ZIF16 for EEPROMs
- Control of contacts in the sockets
- Two expansions sockets (MT & SE)
- Protection against overcurrent
- Overload voltage protection
- Three 3 adjustable voltage and current control: Voltage of power supply ( 2.0...5.0V ), programming voltage (2.0...21.0V), additional static 10V for microcontrollers.
- High-speed bidirectional pin drivers with adjustable voltage (2.0...5.0V)
- Wave cycle generator with frequency ( up to 24 Mhz) and out voltage(2.0...5.0V) adjustment
- Capability of functional emulation of class CDC USB devices
- Built-in 32-bit virtual machine
- Supported interface: I2C, SPI, MicroWire, JTAG, UART, BDM, ISO7816, K-LINE (via adapter), CAN (via adapter)
Orange-5 Installation Guide :
Download the base software from link above.
1. Extract the software from orange5.rar in any location on your PC
2. Open Windows device manager
3. Connect Orange-5 to PC
4. Find Orange-5 in device manager then right click properties ->Driver->Update driver
5. Navigate to driver location (where you extracted orange5.rar ) there is folder Driver [select subfolder X64 if your OS is 64bit]
6. Install the driver
7. Disconnect and reconnect the programmer in order to allow it to reinitialize.
8. Run the program (orange.exe) [depending on the USER ACCOUNT CONTROL settings of your Windows you might need to run the software as administrator ] and the programmer should initialize properly and run.
If you get message "Hardware not detected", but the Mode LED on top of Orange-5 is solid blue and Orange-5 is shown normaly in device manager , check your USB ports/cable (if overloaded/bad contact/etc the programmer won't run)
If the MODE Led is blinking driver is not installed Disconnect and reconnect again the programmer then go back to step 2.